ATI laptop: Added "splash=0" on install...is that ok?
Forum rules
Before you post read how to get help. Topics in this forum are automatically closed 6 months after creation.
Before you post read how to get help. Topics in this forum are automatically closed 6 months after creation.
ATI laptop: Added "splash=0" on install...is that ok?
On install I pressed F6 to edit my installation and replaced "quiet splash" with "splash=0" and I was able to install Daryna without any probs on my ATI laptop.I wanna know..was that ok?
Last edited by LockBot on Wed Dec 28, 2022 7:16 am, edited 1 time in total.
Reason: Topic automatically closed 6 months after creation. New replies are no longer allowed.
Reason: Topic automatically closed 6 months after creation. New replies are no longer allowed.
Re: ATI laptop: Added "splash=0" on install...is that ok?
No, "quiet splash" didn't even get me as far as the installation GUI where you can select to install/safe graphics mode/1st hard disk--I'd get stuck in the usual white-text-black-background screeen. I had to experiment several times until finally getting it to run with "splash=0". It must have something to do with my ATI card.
It's a good thing it worked, too. A few more install failures and I would've opted to go back to gutsy.
It's a good thing it worked, too. A few more install failures and I would've opted to go back to gutsy.